Four steps at the equipment

01

Scan the tag

QR or NFC confirms which unit the technician is standing at and opens its work order.

02

Checklist with PLC hints

Run hours, starts and alarms come from the controller. Only what the eye sees is left to enter.

03

Photos and signature

Photo evidence, a voice note and a simple electronic signature by both the technician and the customer.

04

Report and log

A PDF/A report with a signing record, a log entry, and the next due date based on actual run time.

Target: a routine service in under 3 minutes, with more than half the fields filled automatically.

For operators

  • Preventive maintenance schedule and work orders without paper
  • Sensor readings in the checklist, no manual typing
  • Works offline: workshops, basements, remote sites
  • Contractor control: who did what, and when, at the unit

For equipment manufacturers

  • A verifiable service history for every serial number
  • Maintenance procedures published once, delivered to every customer
  • Failure statistics by component, fed back to design
  • Fleet telemetry — with the operator’s consent

Built for the plant floor

Offline-first

The app never waits for the network; data syncs in the background.

Read-only PLC access

An on-site gateway reads the controller over an outbound connection. No control of the process.

Tamper-evident log

Chained records make back-dated edits visible on verification; reports get an RFC 3161 timestamp.

Your ERP stays in charge

MERA does not replace SAP PM or similar systems — it feeds them the facts from the floor.

MERA Inside: technical notes

An eight-part series of engineering write-ups — offline signing, tamper-evident logs, PLC data, and the architecture for predictive maintenance (in development). Published on Zenodo with DOIs.